1966 XP Falcon – Correction and Modesta Paint Protection | Brisbane

1966 XP Falcon – Correction and Modesta Paint Protection | Brisbane


We were delighted when one of our old customers decided to book in his prized XP for correction and Modesta liquid glass coating.

However, she came in looking more than a little worse for wear. Whilst she is definitely the owner’s pride and joy, it spends a lot of time in the sun without wearing any protection!

As we all know here in Australia the high UV index wreaks havoc on a vehicle’s clear coat. It’s beautiful deep purple paint job looks severely rough, faded and oxidised. It was very good timing to get it in, we don’t think it would’ve been long until clear coat failure in which the only solution is an expensive respray!

NOTE – A quality wax/sealant or coating will provide UV protection and prevent this oxidation.

Onto some photos – BEFORE

Modesta Paint Protection Brisbane

XP Falcon Car Detailing

The oxidation/damage is pretty obvious above. We can tell there’s a beautiful paint job there but it’s currently hidden under all that oxidation!
Luckily there was no actual cracking/clear coat failure. So despite the heavy damage, we know our skillset and knew we could save her.So it was time to get started, after all the necessary washing then decontamination of the paintwork it was straight to work with our trusted Flex Rotary Polisher.

As we’ve mentioned before rotary’s are only ever to be used by a skilled operator, you risk burning through paint and causing holograms if improperly used. Luckily (well not really luck, more like years of practice!) we are well versed in its use.

Even with the power of the rotary, it took a LONG time to get progress on the bonnet, here it is half done…

Best Car Detailing in Brisbane

So we finished off the bonnet and decided to move to the next worst section, the boot and rear quarter panels… As you can see, very bad condition here as well.


So we started on the boot with the same process as the bonnet, however, it was taking far too long. It was about 30 minutes just to get this section cleaned up, not even perfect.
So it was time for a change of plan, we knew the aftermarket paint job. It had thick clear from previous paint depth readings. So we busted out the 2000G and 3000G sandpaper and got to work removing some oxidation. It allows us to get some MUCH quicker results…


We then repeated this process across the car, here are some pics. Some are before/afters or “50/50” shots.



Wetsanding in progress.


Wetsanded area after polishing.



The owner obviously didn’t want her to deteriorate again so chose to have the paintwork coated with MODESTA, the world’s leading paint coating.

We applied the Modesta P-01 primer and BC-04 liquid glass coating. It’s IR cured and then good to go!


Finally, time to head outside for some photos in the beautiful QLD sunshine.

Best Car Cleaning

Mobile Car Cleaning

Car detailing


The owner was understandably ecstatic and emotional! (He won’t mind me adding that)

This is what we’re great at, this is what we love to do! If you want more information or want to get in touch, call us on 1300 85 77 34 or CLICK HERE to send us an enquiry.

Lotus Elise S + Correction + Modesta P-01a + BC-03BMW Z4 – TAC QUARTZ SPARKLE – Paint Protection & Interior Protection – Brisbane, QLD Workshop

Leave a Comment

Your email address will not be published. Required fields are marked *

Latest Post
Most Commented
Text Widget
Primus elit lectus at felis malesuada node ultricies forte uno ligula sande. Porta an urna vestibulum commodo convallis laoreet enim.

Cut and Polish Quick Quote

Headlight Repair & Restoration
Quick Quote

Window Tinting Brisbane Quick Quote

Pet Hair Removal Book Now!

Fleet Detailing Quick Quote

4WD Services Book Now

General Detailing Enquiry

Service Area Free Quote


Swirl marks are microscopic scratches in the surface of paint that show up like cobwebs in bright light. They are caused by incorrecting washing and drying where dirt particles in the sponge and chamois leave microscopic scratches in the clear coat.

Solution – Single stage correction package will remove approximately 60-70% of swirl marks, dual stage 70-85% and triple stage 85-95%.


Lack of Colour depth is where the colour has faded but isn’t classed as oxidised, typical on one stage paints that don’t have a clear coat.

Solution – Single stage correction will improve colour depth however dual stage correction is recommended if you want to remove swirls at same time.


Finger nails, rings and car keys scratch the paint around the door handle and leave unsightly marks.

Solution – Spot machine polishing, although these scratches are usually too deep for 100% correction our spot correction can make these marks almost invisible. Great add for people trying to sell their car. Price $ 20 per panel when added to a detail or $75 call out fee + per panel.


Ghosting refers to the outline or visible stencil left on the paint after stickers/decals are removed. It is the contrast between the fresh paint that was protected under the vinyl sticker and the exposed paint that has faded and appears dull in comparison.

Solution – Spot dual stage machine polishing is the most affordable solution, $45 per panel and $75 call out fee. Depending on the colour of your car spot polishing may not be advised. The polished area will vastly contrast the unpolished paint. Lighter coloured cars can get away with single stage polishing at $20 per panel. Full dual stage paint correctionis recommended on darker coloured cars with these defects.


Oxidised paint is where the paint appears chalky and dull, it’s caused by breakdown of the paint from exposure to sun,water and oxygen. More common on single stage paints and white, red, and black cars.

Solution – Single stage correction can be effective on white or lighter coloured cars with light oxidation. On heavily oxidised cars, dual stage correction is highly recommended. Spot polishing is not applicable and only full correction packages should be considered.


Caused by vegetation and scrub rubbing against sides of the vehicle that leaves visible scuffs. These marks range from swallow to quite deep scratches.

Solution – Dual stage polishing is recommended as the first stage orbital polishing is better suited at resurfacing the affected areas with its more effective cutting action. The second stage of polishing restores gloss and further rounds off the deeper scratches.


Bird droppings are very acidic and start eating into your paint the moment it hits, heat and dry weather will amplify the reaction, it’s important to clean any droppings off as soon as you see them. If you still see a ghosting outline after washing you have an etching mark where its has eaten slightly into your paint. If the mark looks like the one in the picture sourced from meguiars online you only have light etching and this can be corrected with machine polishing.

Solution – Spot dual stage machine polishing is the most affordable solution, $45 per panel and $75 call out fee. Depending on the colour of your car spot polishing may not be advised. The polished area will vastly contrast the unpolished paint. Full Dual stage paint correction is recommended on darker coloured cars with these defects.


Paint transfer is occurs when a car panel comes into contact with another painted object with force and leaves a layer of paint behind. Common paint transfers are yellow paint marks left from bollards or garage door frames. The actual paint transfer can be polished off with great success, however there are usually a few deeper scratches that are left behind. The polishing stage will reduce the appearance of these scratches but if you can see the undercoat on your car, it’s time for respray.

Solution – Spot dual stage machine polishing is the most affordable solution, $45 per panel and $75 call out fee. Depending on the colour of your car spot polishing may not be advised. The polished area will vastly contrast the unpolished paint. Full Dual stage paint correction is recommended on darker coloured cars with these defects.


Bird droppings that have been left too long can eat all the way through the clear coat. If the mark is crazed, or cracking as shown in the pictures this is unfortunately clear coat failure and can only be fully repaired by repainting. The clear coat has been penetrated and no amount of polishing will remove all traces of the defect.

Light crazing and cracking can be vastly improved and is much more cost effective than painting, many customers still opt for an improvement by our Dual Stage spot paint correction. Although we can not guarantee restoration we can make the marks less visable for a fraction of the cost of repainting. Is a popular option for clients trying to improve their cars for sale.


Random deeper scratches are very common and depending on the depth will determine if they can be polished out. The general rule of thumb gives you an instant idea if the scratch is correctable. Run your thumb nail over the scratch and if a indentation is felt then generally the scratch is too deep to successfully correct by polishing. Normal wear and tear will see your car pick up a few deeper scratches over time. If the scratch is a different colour and you can see bare metal or primer, only repainting is your option. Where deeper scratches have not penetrated all the way through the clear coat you have more options.

A popular choice is to get the area polished to reduce the appearance of the marks first and then determine if you can live with the result. Alternately if chasing 100% correction respraying is your next option, remember that respraying just one door panel can cost $350-600. Dual or even triple stage paint correction package may give you a great outcome and permanently reduce appearance of those scratches without the expense of repainting your car.


There are actually three types of water spots but we will only focus on two of the most popular. The first is mineral deposits that sit on top of your paint and is usually a combination of magnesium and calcium. These minerals are soluble in your town water and when the water evaporates from the surface the minerals are left behind causing unsightly water spotting. This type of water spot can be removed with specific chemicals and light polishing.

See our single and dual stage paint correction packages to restore these spots. The other type of water spotting is where the same minerals have been left on the paint for some time and has started to eat into the paint. This causes deep etching and proves very difficult to remove. Due to the excessive time involved to polishing out these defects we do not offer this service in a mobile sense as it takes more than one days labour. Keep posted for our workshop location at the end of the year.


If there is paint missing and the scratches show the undercoat or even the base metal then repainting is your only option.


Clear coat failure is caused by long term exposure to the elements. This comes in the form of bubbling, blistering and peeling. Nothing can be done to fix this apart from repainting. See your local body shop for a quote.


Throwing eggs may seem harmless but cause irreversible damage to car paintwork. The small hard shell fragments cut into the paint at the point of impact and can only be fixed from repainting. A premium quality paint protection like our Modesta Liquid Glass has been know to prevent damage in some circumstances.


It makes my blood boil when I see senseless vandalism. If your car is keyed unfortunately respraying those panels is your only solution.